Thingiverse
40mm Coin Jig
von Landin81
47
Downloads
30
Likes
0
Makes
This is a 6pcs Coin Jig for 40mm coins when laser engraving.
fits all tables with 2.5mm spacing center of holes.
Uses two M6 screws to hold it in place.
Recommended printing in PETG or ABS due to the heat from the coins, PLA is fine also if not doing deep engravings.
EDIT: Also added a jig without a bottom to get some more heat transfer down to the aluminium bed if doing longer engravings.
fits all tables with 2.5mm spacing center of holes.
Uses two M6 screws to hold it in place.
Recommended printing in PETG or ABS due to the heat from the coins, PLA is fine also if not doing deep engravings.
EDIT: Also added a jig without a bottom to get some more heat transfer down to the aluminium bed if doing longer engravings.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
