Thingiverse
40mm Cube Test Object
von bre
1.5k
Downloads
1.1k
Likes
60
Makes
This is a simple cube that tests the settings of your 3D printer. I tested it on my MakerBot and it came out within .5mm of 40mm on each side.
The two of the corners came up a bit. I\'m going to make a bigger raft later and see if I can correct that.
The two of the corners came up a bit. I\'m going to make a bigger raft later and see if I can correct that.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
