Ender3 Pro Stepper Motor Cooling Ducts

I made cooling ducts for my Ender 3 Pro as the stepper motors were getting very warm. These are designed to fit two 60mm fans I had laying around.
There are no mounting holes in the Y Duct, so you will have make them to suit how you want to mount it.
The X-Z Duct just clips on and has a mounting for a cable chain I found here on Thingiverse(thing:2920060)
The wires run through the hole at this mount and then on to the motors etc.
I mounted the fans so that they would suck the air out of the