Thingiverse
.45 Caliber Stackable Ammo Box (Scaled Properly)
by tmindustries
3
Downloads
2
Likes
0
Makes
Re-built the box from scratch in TinkerCAD since the original model refused to scale properly for me in both Cura and Fusion360. Round compartments are 12.5 x 12.5mm since the original 12mm size was much too tight, at least in my experience.
Haven't printed two yet to know how well they stack but the lip is a few mm deep so it should suffice.
Print upside-down and you shouldn't need supports, 12.5mm bridging is pretty easy.
Haven't printed two yet to know how well they stack but the lip is a few mm deep so it should suffice.
Print upside-down and you shouldn't need supports, 12.5mm bridging is pretty easy.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
