MakerWorld
Other Hobby & DIY
Go to Model
45 degree LED Strip Mount
72
Downloads
18
Likes
41
Makes
This is a simple holder I made for the common LED Strips. You can usually slide the strips in, but you can also lay one side in, then press the other side down into the channel too install them. it has a 45 degree surface on the back so you can put it flat, or in the corner on a 90 degree bend.As is, it is 100mm long but scaling can adjust the length and how tight it fits.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
