Thingiverse
45° sectioned Level 3 Menger Sponge
door scruss
0
Downloads
2
Likes
1
Makes
This is my 45° sectioned Level 3 Menger Sponge. There are many like it, but this one is mine^H^H^H^H ours.
Because this has so many paths, this will be quite a noisy workout for most filament-based printers. The model is constructed differently from most Menger Sponge models, and I will be releasing one with OpenSCAD source in due course.
This was designed and printed on a ridiculously hot day at [Protolab](http://www.protolabto.com/ "Protolab") in Toronto.
Because this has so many paths, this will be quite a noisy workout for most filament-based printers. The model is constructed differently from most Menger Sponge models, and I will be releasing one with OpenSCAD source in due course.
This was designed and printed on a ridiculously hot day at [Protolab](http://www.protolabto.com/ "Protolab") in Toronto.
scruss publiceert ook op
92 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
