45mm circle furniture / table / bed riser

Material used: SUNLU PETGprinted for strength, but it has not been stress tested. the table I am supporting is ~100lb but it is supported by 4 of theseit should not be a tight fit. I made the hole 47mm so it has some wiggle room just in case the fit is too tight there are 3 plates. If you want to check the fit, print the 1 leg first, then print the remaining 3. If you want to just do 1 print, just print the plate with 4 legs.or just clone as many legs as you likeif anyone can make a parametric model that would be cool I have another furniture riser for rectangular legs