463mm MLOK Hex Handguard
door Leucoemeraldine
33
Downloads
20
Likes
0
Makes
Barrel nut threads directly to upper receiver. Handguard threads into barrel nut and is held together with two or three M3x0.5x12 screws. You can slice the model to a shorter size if you want. Just sand and superglue the edges to put them together.
Depending on your print settings this will take about 22 hours at 0.2mm layer height and 200g (PLA filament).
Depending on your print settings this will take about 22 hours at 0.2mm layer height and 200g (PLA filament).
Leucoemeraldine publiceert ook op
7 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
