Thingiverse
49cc Bicycle Motor Pull-start Bushing
0
Downloads
0
Likes
0
Makes
No more buying new pull-starts every time that bushing wears-out.
No more frayed and shredded pull-cords.
Now you can print your own for less than 0.7g of material.
Fits 10mm pull-start holes
Print out of ABS or Nylon (if able)
Print in shown orientation (upside-down) without supports
PLA is too soft (but I won't stop you from trying, i'm not your dad)
Fitment is going to be TIGHT. You WILL need to 'tap' it into place with a soft-hammer.
~Aegis Defence Corp.
No more frayed and shredded pull-cords.
Now you can print your own for less than 0.7g of material.
Fits 10mm pull-start holes
Print out of ABS or Nylon (if able)
Print in shown orientation (upside-down) without supports
PLA is too soft (but I won't stop you from trying, i'm not your dad)
Fitment is going to be TIGHT. You WILL need to 'tap' it into place with a soft-hammer.
~Aegis Defence Corp.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
