Thingiverse
4AA Battery Holder
by AndreaRade
22
Downloads
19
Likes
0
Makes
This is a 4AA battery case (58,5x61,5x16mm).
It needs a little bit of soldering and copper cables.
It can be a little bit difficult to pass all the cables inside the holes.
I suggest to bend the end of the cable to go in easier and a needle to take it out from the holes.
Starting from the holes at the bottom was easier for me.
It needs a little bit of soldering and copper cables.
It can be a little bit difficult to pass all the cables inside the holes.
I suggest to bend the end of the cable to go in easier and a needle to take it out from the holes.
Starting from the holes at the bottom was easier for me.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
