Thingiverse
4runner Ram Sammich Mount
par microtendo
3
Téléchargements
3
Likes
0
Makes
Work in progress so no promises!! Ram ball has a hole for M4 35mm bolt. Probably will need to slightly drill to fit.
Original: first prototype, was a good length, but a little narrow.
W/ Taper: added 3/16" taper to each side and took 1/4" off the bottom to get it to wedge it in. Untested, please pass along feedback of build!
Wide: the original, but 3/16" added to each side. Untested! This may be snug!! Please pass along feedback
W/ Holes: Holes should fit tubes of chapstick
Original: first prototype, was a good length, but a little narrow.
W/ Taper: added 3/16" taper to each side and took 1/4" off the bottom to get it to wedge it in. Untested, please pass along feedback of build!
Wide: the original, but 3/16" added to each side. Untested! This may be snug!! Please pass along feedback
W/ Holes: Holes should fit tubes of chapstick
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
