Thingiverse
4S 18650 Pack Holder
by RyanS_ZA
14
Downloads
7
Likes
0
Makes
Top and Bottom holder for 18650 4S1P packs. Wanted it to be as light as possible, but still functional.
Zip-tie securing idea came from:
https://www.thingiverse.com/thing:4628783 by wrong17
Just put your 18650 cells in the holes, with the blocks underneath the cells. Solder wires while in the holder. Put balance leads through the hole in the center, and use the inner guides to secure balance wires. If unsure, look at the photos as to how I used it.
DISCLAIMER:
Soldering batteries is EXTREMELY dangerous. I am not and will not be responsible for any fire or damage cuased by using this. Use at own risk and be extremely cautious.
Zip-tie securing idea came from:
https://www.thingiverse.com/thing:4628783 by wrong17
Just put your 18650 cells in the holes, with the blocks underneath the cells. Solder wires while in the holder. Put balance leads through the hole in the center, and use the inner guides to secure balance wires. If unsure, look at the photos as to how I used it.
DISCLAIMER:
Soldering batteries is EXTREMELY dangerous. I am not and will not be responsible for any fire or damage cuased by using this. Use at own risk and be extremely cautious.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
