Thingiverse

4x4.5 Propeller

por LasagnePrints

207 Descargas

163 Likes

4 Makes

As I now fly small FPV racing quads I decided that I would try and print a smaller propeller for them. I hope you enjoy the result. So far they have been working well on my Diatone Tyrant 180. If you fine tune your printer then I am confident that these props will come off the print bed without needing to be balanced/sanded/reamed etc.

I have found that these print best with a large layer height and a slow print speed. I would recommend a print height of 0.3mm and a speed of 20-30mm/s. 100% infill is always best but I have found even a 20% infill works well. Also if you keep your nozzle temperature and bed temperature high then the props are stronger I have found.

I have been printing exclusively in PLA so far with great results. I have yet to try these in ABS or any other material but I am sure they would be fine.

If you're like me and you break a lot of props then 3D printing new ones is a cheap and quick way to get your quad back in the air. These aren't meant to be bett

250 Quad 250 quadcopter 4x5 diatone Diatone 250 drone fpv fpv250 fpv racer fpv racing hobbyking ImmersionRC Vortex miniquad motor prop propeller propellor props prop guard quad 250 Quad 250 quadcopter 4x5 diatone Diatone 250 drone fpv fpv250 fpv racer fpv racing hobbyking ImmersionRC Vortex miniquad motor prop propeller propellor props prop guard quad

Fuente

Thingiverse

Lo que necesitas para imprimir: Principiante Baja confianza

Pieza única

Soportes 1/3

Ensamblaje 0/3

Ajustes 1/3

Tamaño de cama 0/3

Postproceso 0/3

Impresora

FDM / FFF

Formato de archivo