4x4 Macropad Case
von SargentRedbeard
5
Downloads
5
Likes
0
Makes
This prints in place with no supports needed and does not require any rework after completed. I made this for the 40PercentClub 4x4 macropad but should fit most 4x4 macropad pcb's. The only thing you will need are some rubber feet for the bottom. I used these, found at Home Depot: https://thd.co/31Mu6vu
This is v3.3.
This is v3.3.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
