Thingiverse
4x6 Label Roll Holder
von emerbaum
10
Downloads
7
Likes
0
Makes
I didn't want to pay 20 bucks for a label holder for my shipping labels.
Knocked this out in tinker in 5 minutes.
Prints on one plate.
Glue the legs to the frame.
Stick goes through.
If you cant figure it out, this might not be the hobby for you.
$1.32 in filament vs 20$ for a proper holder.
Knocked this out in tinker in 5 minutes.
Prints on one plate.
Glue the legs to the frame.
Stick goes through.
If you cant figure it out, this might not be the hobby for you.
$1.32 in filament vs 20$ for a proper holder.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
