5 Gallon Bucket Internal Support

I recently purchased a dust extractor and the vacuum can collapse the 90mil 5 gallon bucket. I have a cyclone to separate the dust into the bucket. The bucket will collapse eventually no matter how careful I am with the hose and usage. I created this internal support to insert into the 5 gallon bucket to keep it from collapsing. I plan to use three of them and since the bucket has a slight taper in the further inside the bucket. I have printed at 100%, 95%, and 90% and these seem to work for the bucket I have. It is recommended to measure the ID of the bucket and if it is above 290mm you will need to scale it I recommend printing three of the for maximum support.The print profile used is 0.4mm nozzle with Bambu ABS using 0.20 Strength profile and some slight modifications in the strength parameters tab. The infill is set to gyroid at 50% for strength. I found that printing any higher infill provides no additional strength. I included the first version of the file of the part where I ha