Thingiverse
5 point 2 layer drone test 9 min
por Spotmaticxl
5
Descargas
2
Likes
0
Makes
This should take about 8-10 min to complete. Watch after each square is printed then adjust the side as needed. Repeat once more after adjusting to endure level is proper. If middle square first layer is warped on the first layer, stop and adjust all four sides evenly, then restart.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
