5 Point Angled Slide

A simple angled slide with stop points. You will mostly likely want to edit it to have screw holes where you need.

The pin is set to a very tight fit, as the project I need this I needed the pin to be tough to move between "slots".

The hole for a screw through the pin and cap is set to 1mm, and the entire piece is 70mm x 70mm. I could probably reduce the size of the plate, but at this time I didn't need to.

This was created in FreeCAD. This is my first model from FreeCAD and my first model shared on Thingiverse. Hopefully someone else can find this useful.

Feedback on the model is very welcome!