50 cc piston stand

This is my first upload on here and I decided to make this piston stand/holder for a 50 cc piston I had laying around from my seized piaggio fly 50cc 4t 2009 engine;

-I think it should fit most 50cc pistons.

-The hole that connects to the base gives the possibility to change the angle the piston sits at (not sure if its very usefull and will most certainly fall if not glued down).

-Base-1 and Base-2 needs to be glued together.

-After printing I found the top hole really tight so I made a v2 with a bigger hole.