50 Pixel 17 Inch Snowflake

This is a remix. It is adjusted it to have 50 pixels and overlapping parts. I have made it a different thickness and overlapped the components so that they lay flat when assembled.

If you print it with better than .3 accuracy the overlapping holes/posts will probably be a little loose. I generally print my snowflakes in pretty much draft form since they aren't going to be inspected up close but instead used in an outdoor light display. I use CA glue to keep them together although just inserting pixels will also hold the snowflake together just fine if you want to disassemble them every year.

Make sure you have supports turned on for part A. Part B does not need supports. Print 5 of each part. xModel coming soon.

UPDATE: Use rev 2 of Part A. The posts are all on one side so that they print better to fit in the part B holes. It still needs supports but the holes print much easier than the posts with supports.

Part B has not changed - use rev 1.