Thingiverse
50mm PikoButton Camera Mount
13
Downloads
11
Likes
0
Makes
An adapter for connecting a medium 50mm water resistant PikoButton to camera-type mounts. This adapter is based on the style of similar mounting adapters by [ATMakers.org](https://atmakers.org).
To assemble the mount with the switch, you will need:
1 - 3D Printed Mounting Adapter
2 - M4 machine screws, 12 mm long
1 - 1/4"-20 UNC tee nut, 5/16" long (e.g. https://www.mcmaster.com/90975A025, also available at hardware store)
You will also need the following temporarily to install the tee nut:
1 - 1/4" Washer
1 - 1/4-20 UNC machine screw or bolt, 3/4" - 1-1/2" length
Volunteer your 3D printing skills to help people with disabilities in your community!
Makers Making Change is an initiative of the Neil Squire Society, a Canadian non-profit that helps people with disabilities.
We are committed to creating a network of volunteer makers who support people with disabilities in their communities through 3D printing assistive devices. Check out our
To assemble the mount with the switch, you will need:
1 - 3D Printed Mounting Adapter
2 - M4 machine screws, 12 mm long
1 - 1/4"-20 UNC tee nut, 5/16" long (e.g. https://www.mcmaster.com/90975A025, also available at hardware store)
You will also need the following temporarily to install the tee nut:
1 - 1/4" Washer
1 - 1/4-20 UNC machine screw or bolt, 3/4" - 1-1/2" length
Volunteer your 3D printing skills to help people with disabilities in your community!
Makers Making Change is an initiative of the Neil Squire Society, a Canadian non-profit that helps people with disabilities.
We are committed to creating a network of volunteer makers who support people with disabilities in their communities through 3D printing assistive devices. Check out our
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
