Thingiverse
510 Drip Tip
von Mike-vom-Mars
143
Downloads
113
Likes
0
Makes
###510 DRIP TIP
Drip tip for 510 e-cigarettes (like Joyetech AIO Pro C and others). Easy to print, perfect fit.
The drip tip can hold two o-rings but using a single o-ring per drip tip also works. It even works without any o-rings but they should be used to give an airtight fit and to prevent any leaking of your liquid.
Recommended o-rings: 6.0mm diameter x 1.0mm
Cheap o-rings can be obtained here (Germany): https://bit.ly/2FfpAxW
####PRINT SETTINGS:
> Flow: 105-110%
> Layer height: 0.1mm
> Wall thickness: 0.8mm
> Line width: 0.48mm
> Top / bottom line width: 0.58mm
> No supports required
> Infill: as more, as better (gives stability)
> Disable coasting!
Drip tip for 510 e-cigarettes (like Joyetech AIO Pro C and others). Easy to print, perfect fit.
The drip tip can hold two o-rings but using a single o-ring per drip tip also works. It even works without any o-rings but they should be used to give an airtight fit and to prevent any leaking of your liquid.
Recommended o-rings: 6.0mm diameter x 1.0mm
Cheap o-rings can be obtained here (Germany): https://bit.ly/2FfpAxW
####PRINT SETTINGS:
> Flow: 105-110%
> Layer height: 0.1mm
> Wall thickness: 0.8mm
> Line width: 0.48mm
> Top / bottom line width: 0.58mm
> No supports required
> Infill: as more, as better (gives stability)
> Disable coasting!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!