5ft Lighted Stargate

5ft Lighted Stargate controlled by arduino
(Just a heads up its a very long print 900+ hours)
- Not a beginner project. Need an understanding of wiring/soldering. Need a understanding of programming arduino boards to load my program.
- Stargate Activation video link https://youtu.be/aMC3CDZYe2s
- Stargate Glyphs Spinning video link https://youtu.be/WGO_9QlkYmY

The Stargate is designed to snap together using dovetail connections and superglue to make the assembly permanent. Sanding on some pieces may be needed to make them fit better. I have tweaked the design since i printed it to give more room for wire management, use less plastic, and to make pieces fit together better.

I wired the wormhole LED's in 6 different zones (see "Wormhole Wiring Zones" image) to give it an event horizon puddle effect on the wall.

For wiring use the "Wiring Diagram" image.

Setting up the audio files: Unzip and add the 4 audio files onto the micro SD card.

Things you'll need:
- a 3D pri