Thingiverse
Electronics
Go to Model
5mm LED holder including nut.
138
Downloads
114
Likes
1
Makes
I remixed the 5mm LED holder including nut.
2614745
Thank you Kleinz1971.
I made two versions, a closed version and an open version.
If you print this in white or clear, then the LED will shine through the plastic.
It only has to go through 0.5mm's of plastic.
The holder will fit into a 3/8" or 10mm hole.
I made the housing a little shorter and I scaled up the nut a little so it fits easier. Now it is a 13mm nut.
I wanted a way to make a soft back light behind this ceiling fan remote controller.
This works great. I left the nut off the holder and threaded it into a 3/8” hole in my wall.
Printed in PLA .2 layer 25% infill
2614745
Thank you Kleinz1971.
I made two versions, a closed version and an open version.
If you print this in white or clear, then the LED will shine through the plastic.
It only has to go through 0.5mm's of plastic.
The holder will fit into a 3/8" or 10mm hole.
I made the housing a little shorter and I scaled up the nut a little so it fits easier. Now it is a 13mm nut.
I wanted a way to make a soft back light behind this ceiling fan remote controller.
This works great. I left the nut off the holder and threaded it into a 3/8” hole in my wall.
Printed in PLA .2 layer 25% infill
Old-Steve also publishes on
1 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
