Thingiverse
5mm Shelf Hanger
von Taylor-eOS
0
Downloads
0
Likes
0
Makes
A hanger for placing tools on a 5mm shelf hole.
You need one base and three pins. Or just the base and use sticks.
Getting the pins to fit is a bit difficult. Either adjust the `clearance` to your printers demands, or use horizontal expansion in the slicer.
You need one base and three pins. Or just the base and use sticks.
Getting the pins to fit is a bit difficult. Either adjust the `clearance` to your printers demands, or use horizontal expansion in the slicer.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!