5th Gen 4Runner Alpine Microphone Mount

--- Update 1:16pm, April 28, 2021 ---

Disregard all previous files and designs. The design was no good and was impossible to install the Alpine Mic. I've redesigned the engagement points of the 3D print so that it captures the Alpine mic and allows for install from the top. The previous design was no good because the print could not flex enough to allow for the mic to be installed.

I've tried it with 2 different Alpine Mics (both have pretty large variations in the OD, 13.83mm to 14.14mm)

The model is now sized at 14.25mm ID with a tab that prevents the mic from falling out through the bottom, and a top tab that is captive with the slots for the body of the mic.

Again...
PETG or better material (PLA is not recommended)
100% infil
Supports everywhere


----



--- Update 11:30pm April 27, 2021 ---

A friend brought over his Alpine mic after he told me the print didn't fit his Alpine mic. He too is about to install an ILX-F309 into his 4runner. His Alpine mic di