6.5" Speaker Box

I based this speaker box remix on a model I found on Cults. (Many thanks to 3DVerse for sharing!) Here is the original description: "Closed speaker box for 6.5"(16cm) speakers with XT60 connector at the back. Designed to be printable all at once at an ender 3 build plate and use m4 nuts and bolts." Original settings: "10% infill -> 1kg fillament10-20% infill advisedTree Supports" I made a minor edit to both speakers boxes (right and left): I created new, bigger, XT60 mounting holes on the back of the boxes, since the original holes were significantly smaller than the XT60 sockets I bought off Amazon… I had to cut the holes bigger manually (which was a pain.)After spending the majority of a roll of filament on these boxes, I did NOT want to reprint them!!I made the holes bigger, which should work out much better for you. The XT60 sockets I used:https://www.amazon.ca/dp/B0C5X5Q1NN I printed my boxes in PLA, with 20% infill and tree supports. (PLA since these are being