Thingiverse
6 channels relay board case
by Lyrkan
4
Downloads
2
Likes
0
Makes
Small case for a 6 channels relay board.
The board can be attached to the bottom part using 3mm heat set inserts.
Output wires can be zip-tied to avoid unnecessary stress on the screw terminals.
The relay board I'm using is 106mm long and 56.6mm wide.
Can be printed without any support.
The board can be attached to the bottom part using 3mm heat set inserts.
Output wires can be zip-tied to avoid unnecessary stress on the screw terminals.
The relay board I'm using is 106mm long and 56.6mm wide.
Can be printed without any support.
Lyrkan also publishes on
21 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
