Thingiverse
608 cap for pulley
von cacvalle
2
Downloads
3
Likes
0
Makes
THIS IS NOT YET PRINTED!!!
i made this part for the anet a8 bearings that is just too bad... may print better or whorse...
my ideia is to remove the bearing in the X and Y axis to include thesse 608 bearings... i thint will improve a little... when i print i will sant comparation of the files
i made this part for the anet a8 bearings that is just too bad... may print better or whorse...
my ideia is to remove the bearing in the X and Y axis to include thesse 608 bearings... i thint will improve a little... when i print i will sant comparation of the files
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
