60mm fan deflector

40'ish degree deflector for a standard 60mm fan with 50mm hole spacing for M3 bolts.

Slicing directly from the STEP files usually produces the best results, but included STL files too.

**Material:** I used Polymaker PolyMax PLA but any PLA+ filament or other tough filament should do.

**I used these print settings with good results:**
Nozzle size: 0.2 (should be just fine to use a 0.4mm nozzle with 0.2mm layer height)
Layer height: 0.16
Walls printing order: Inner/Outer/Inner
I adjusted top/bottom layers until the part is solid all the way through