Thingiverse
Linear Bearing for a v2 RapMan
by blokkendoos
9
Downloads
5
Likes
0
Makes
A Y-axis bearing upgrade for a Bits From Bytes RapMan (2008 version 2)
Printing two Stanford bunnies was too much for the Y-axis :-)
To replace the bearing, loosen the cornerblock bolts and slide out the bar just enough to replace the bearing. I put a short piece of 8mm rod in the cornerblock both to push the rod out and at the same time keep the loosened cornerblock stable.
The length of the block is such that it can be printed on a TOM or MakerBot. If you have a larger capacity 3D prin
Printing two Stanford bunnies was too much for the Y-axis :-)
To replace the bearing, loosen the cornerblock bolts and slide out the bar just enough to replace the bearing. I put a short piece of 8mm rod in the cornerblock both to push the rod out and at the same time keep the loosened cornerblock stable.
The length of the block is such that it can be printed on a TOM or MakerBot. If you have a larger capacity 3D prin
Sign in to leave a comment
Sign in