LED Light Mount for Ender 3 V3 KE

4-1-2024: REVISED due to noticing a little bit of sag because these lights are a bit on the heavier side for LED's. Added a small little clip on the rear leg and the problem is gone. I have seen many light bracket mounts for Enders, however, nothing to fit these LED Motion Activated lights I purchased on Amazon. These clip the light tightly and fit the gantry cross member very securely. Set the motion sensor and you have light anytime your machine is moving and shuts off when idle.If you have these Auxoda LED lights then, these are the brackets for you.