Other STL Download - Fallout (themed) Bookendby Eskimo Pie

This is a Fallout themed bookend for your Fallout book collection or other books as well. The bookend features two scenes of the vault door both from the inside and the outside. The inside is lined with rivets to a sealed vault door clean and protected from the wastes outside. A Vault-Tec propaganda poster is on the wall to the left of the door. Grates on the floor lead up to the vault door.On the other side of the door is the view from the outside of the vault. The floor and walls around the door are shattered tile in the same pattern from where the shock-wave of the atomic blast hundred of years earlier wrought destruction. The vault door sealed scarred from hundreds of years of exposure to the wasteland. To the left of the door lies a long deceased vault dweller decomposed with bits of their vault suit still intact with their 10mm pistol lying on the ground beside them. Scratches on the left bottom side of the door are indicative of the vault dwellers demise as they died defending themselves from their attacker.The Vault-Tec logo and Vault Boy giving the thumbs up is imprinted on the side facing the books.You will need to print two and they will show both themed sides while on either end of the book collection. Add grippers on the bottom to give it grip.3D printing settingsFirst layer: 0.23mmRest of layer resolution: 0.16mmSupports: Yes, organic/tree to build plate only.Overhang support: 60°.Brim: Use your judgement. I printed with a skirt with five loops on a glass smooth bed instead of textured. It has a decent enough bottom surface area that it should hold on if you get a good first layer.Print time will depend on your printer speed. I recommend patience for better results.Infill: grid 20%