67 Meme Kid - Hueforge

Hueforge print of the 6-7 Meme Kid with a colourful starburst background. I have designed this print in such a way that you can replace the first 2 colours with any other 2 similar colour pairs. One example using Bambu Red and Orange is pictured. You can also print this with only 4 colours by replacing the Yellow section with White, and the white is repeated. Make sure to follow the below instructions clearly. The 3MF should have everything pre-configured.If you use the STL, make sure to set the Pause/Filament swaps as per the description below. Make sure your printer and filament is well calibrated, printing at very small layer heights of 0.08mm Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mmYou may print at higher layer heights below the Base Thickness of 0.6mmRecommended to use a “Height Range Modifier” to print at layer height of 0.20mm between 0.0mm and 0.6mm to speed up initial layers.The Model is 150x100mm in sizeThe Max allowed Thickness is 2.6mm a