3D Printer Parts STL Download - K2 Plus Y-Coupling - CFS and Side Spoolby Shenanigans

K2 Plus Y-fittingWorks with the CFS buffer module mounted to the printer or on the CFS (shown)Requires:- 3X Flush-mount tube fittings (found by searching "pneumatic fitting hot end")- 1X M3x35 screw (removed from the printer during unboxing)- 1X M3x12 screw (optional)Print fitting vertically with single-hole side on build plateInstallation:- Remove the rubber tip from the fittings if needed. Make sure the plastic part stays on as shown in the third pic.- Press (or hammer, your call) the tube fittings into the holes at each end- Thread the M3x35 screw into the screw adapter- Remove the tube coupler from the back of the printer. The tube fitting inside the printer can be pulled back or removed to make installation easier.- Remove the back-panel screw near the tube fitting- Insert the tube into the single side of the Y fitting- Screw the Y fitting into the back of the printer using the Screw Adapter (or an M3x12 screw)- Insert the tube from the CFS into the bottom fitting- Insert the tube from the side spool holder into the top fitting