6m Monoband Hexbeam

A monoband very easy to build Hexbeam antenna for 6m.
Print one base and 6 wire holders. Wrap 3-4 rounds of rg-58 coax around the circular neck as an ugly balun-choke. You can put cable ties through small holes to keep your balun in place. Put the coax through the the hole to the top. Use 2 self tapping screws to connect both coax ends and radiator wire ends. (use ring terminals on wires and coax ends).

Put some CA or glue of your choice on 16mm pvc electrical conduits and push them in holes to the very end without sticking out on the inner side.

How to prepare wire sets is described here:

http://www.hex-beam.com/wire-sets/

Length of wires and spacer cords are here:
http://www.hex-beam.com/specs/

Length of the arms can be seen below:

http://www.hex-beam.com/spreader-arms/

Depending on how precise you prepared the wires and spacer cords, location of your wire holders may vary between 83-88 cm from center of base plate to have a little bit of tension on wires to