MakerWorld
Other Hobby & DIY
Zum Modell
6mm BBs Bullets (Optimized for Printing)
507
Downloads
69
Likes
234
Makes
For best results, supports and a raft are required.After printing, lightly grind/sand the bottom surface and pop the bullets out of the supports with a bit of force. This final step is essential to achieve a clean and accurate result. Once finished, you’ll get uniform, well-shaped BB bullets ready for use.🖨️ Prints as a plate of 10 BB bullets⚙️ Supports required🧱 Raft required🛠️ Light grinding/sanding of the bottom recommended✋ Remove from supports with gentle force🎯 Optimized for consistency, not convenience
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
