Thingiverse
Electronics
Go to Model
6mm push button housing
101
Downloads
89
Likes
0
Makes
This is an enclosure for a 6mmx6mm push button.
I like the cheap buttons because of the the nice "push feeling". I wanted to have a base, which I can use to put these buttons on electronics housings.
You need to print 3 parts:
* The base - There you put in the button (bend the legs and solder cables to it upfront)
* The pin - This is the pin, place it on the button
* The housing - Put everything in the housing (super glue it together)
That's it!
I like the cheap buttons because of the the nice "push feeling". I wanted to have a base, which I can use to put these buttons on electronics housings.
You need to print 3 parts:
* The base - There you put in the button (bend the legs and solder cables to it upfront)
* The pin - This is the pin, place it on the button
* The housing - Put everything in the housing (super glue it together)
That's it!
ringo2k also publishes on
9 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
