Thingiverse
6mm Supportless Mech - Anvil
84
Downloads
96
Likes
0
Makes
The backbone of Republic forces, the Anvil takes a beating while blitzing or occupying enemy territory.
Supportless and easy to print on FDM, this 6mm mech prints in just 2 pieces! The bottom usually prints very easily but the top requires good bed adhesion so maybe add a little hairspray, glue stick, or brim if you're concerned about failures.
"I feel like you see Anvils piloted by rebels almost as frequently as republic strike forces nowadays. Not too surprising since every 'pacified' territory is teeming with freedom fighters."
Supportless and easy to print on FDM, this 6mm mech prints in just 2 pieces! The bottom usually prints very easily but the top requires good bed adhesion so maybe add a little hairspray, glue stick, or brim if you're concerned about failures.
"I feel like you see Anvils piloted by rebels almost as frequently as republic strike forces nowadays. Not too surprising since every 'pacified' territory is teeming with freedom fighters."
SkellifyMinis also publishes on
9 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
