Thingiverse
6x AAA-mag
von Deformist
69
Downloads
48
Likes
0
Makes
2 pieces, shell and spring.
This is experimental, to see how well (or not) a 3d-printed spring holds up.
PLA is probably not great for the spring, PETG should be better.
No supports needed. Print spring on its side.
Edit: Spring gets weak, even with PETG. I'll leave it here though in case someone figure out something.
This is experimental, to see how well (or not) a 3d-printed spring holds up.
PLA is probably not great for the spring, PETG should be better.
No supports needed. Print spring on its side.
Edit: Spring gets weak, even with PETG. I'll leave it here though in case someone figure out something.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
