Thingiverse
7" LCD Display Case
von pteppic
1
Downloads
2
Likes
0
Makes
A case for a 7" LCD display (destined for the trashcan) with a cheap (chinese) controller board.
This started as a test whether the board actually worked with this type of display, and additionally if i could fit all parts in a minimal case.
The case works quite well, the display is just push-fit into place and fixed into place with the controller base-plate. Finally everything is squished into place by the back-plate.
If you should decide to print this, you'll need 4x M2.5x8 (case), 1x M2.5x6 (controller) button-heads and 6x M3x6 (PCBs) countersunk screws.
This started as a test whether the board actually worked with this type of display, and additionally if i could fit all parts in a minimal case.
The case works quite well, the display is just push-fit into place and fixed into place with the controller base-plate. Finally everything is squished into place by the back-plate.
If you should decide to print this, you'll need 4x M2.5x8 (case), 1x M2.5x6 (controller) button-heads and 6x M3x6 (PCBs) countersunk screws.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
