7" Raspberry Pi Touch Screen Mount for 2020 Extrustion

Currently Working on V2 that will mount on the bottom of the machine.

This is an easy to print and install stand/mount for this [ https://tinyurl.com/s2l43n5 ] 7" touch screen. I'm using it with OctoPrint and TouchUI to control my Creatliy CR-10S. Very simple design only takes about 4-5 hours to print based on the settings you use. No supports needed if printed in the orientation pictured above from the slicer screenshot.


Note: You may have to slightly enlargen the holes with a drill bit.

Mounting Hardware:

2- M3x8 Screws
2- M3 Nuts
2- M3 Washers
2- M4x12 Screws
2- T-Slot Nuts