Thingiverse
7 Segment Display Holder
von BennyMan455
7
Downloads
1
Likes
0
Makes
This is a holder in which fits a standard size single digit 7 Segment Display. Designed to be mounted from behind so that the Display fits through a cutout on a board
PLEASE NOTE : 7 Segment Display does NOT sit flush with the holder, but protrudes roughly 1 - 3 mm (depending on chosen pin attachment).
PLEASE NOTE : 7 Segment Display does NOT sit flush with the holder, but protrudes roughly 1 - 3 mm (depending on chosen pin attachment).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!