737 KORRY Annunciator with Working button

Hi Guys,

This has been asked for so many times, I thought id better get it on here.

This has been simplified to remove the PCB board at the back allowing it to be much simpler and people can just press print and go. I spent the last 24hrs tweaking the design to make it quicker, faster and better. I have tested these and have a whole pile on my desk right now. It works really well.

The components just press fit, and then designed to be held with hot glue. Solder your wires to the back and your done. It takes around an hour to print both parts.

You will require a 6mm tactile switch with 7mm extension and two leds which are dependent on the color of the annunciator.

I have included a lens template so you can just cut around it on perspex.

These are designed to work directly with Cockpitsimpart.co.uk Lens, but you can make your own if required.

The size is a little bigger than normal that fit into a mating receptacle. I used hot glue to secure them in place.