75mm micro quad frame

Summaryi found abs>pla, but i guess nylon or polycarbonate is even better. i use tpu for the feed this copter is a blast to fly, flips & rolls very fast, insane yaw rates are possible. frame is tough and can take a hit. I tried with PLA first, but it is heavier and tends to shatter, even though it appears tougher. Print at 100% infill to get maximum toughness. Weighs about 6g. use 380mAh batteries, ~4 minutes airtime.board:http://www.banggood.com/Eachine-FRF3_EVO-Brushed-Flight-Control-Board-Built-in-FRSKY-Compatible-SBUS-8CH-Receiver-p-1091779.htmlmotors:7x20mm coreless motors, e.g.:http://www.banggood.com/4X-Chaoli-CL-720-7x20mm-Coreless-Motor-for-90mm-150mm-DIY-Micro-FPV-RC-Quadcopter-Frame-p-1070123.htmlprops:http://www.banggood.com/5-PCS-HM830-RC-Paper-Plane-Blade-Replacement-p-916674.html( i prefer these ones over the 3 blade props linked below, but you need a 0.9mm or 1.0 mm drill to make them fit on the motors)-OR-http://www.banggood.com/5X-Eachine-3-Blade-Propeller-Prop-20Pcs-