Slicer Discord
75mm Reusable Spool – 3D printable model from MakerWorld MakerWorld
3D Printer Accessories

75mm Reusable Spool

83 Downloads
24 Likes
52 Makes
Go to Model
This is the equivalent of the Bambulab Refillable Spool but for eSun cardboard spools.Boost MeDid you find this model useful? Please consider boosting it to give it some visibility, it helps a lot!WARNING: this model applies only to eSun cardboard spools with a 75mm core diameter, please read below before proceeding.eSun filaments are a cheap alternative and are easy to source from Amazon, but the cardboard spools are not AMS-friendly and can also get easily damaged while shipping. I find all the so-called adapters unreliable inside the AMS and re-spooling is often a messy job, so I decided to design this.Some eSun cardboard spools have a smaller core inner diameter when compared to Bambulab refills so, before ripping off the cardboard shoulders from the filament spool I strongly advise checking the spool core inner diameter using the Spool Core ID Tester: if the measured diameter is 75mm then this model, as an adaptation of the printable version of the Bambulab Refillable Spool, can c
Category
3D Printer Accessories
Source
MakerWorld
Published
Updated
What you need to print this: Beginner Low confidence
Why?
2 colors
Single piece 2 colors / AMS
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
Colors
2 (AMS/MMU recommended)
Software
Cura, PrusaSlicer, or similar
Same designer, more platforms

rlogiacco also publishes on

14 additional models across 1 more platforms

Verified by matching model titles across platforms.
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection