7x64mm bullet

This is a 7x64mm ***fake*** bullet.
7x64mm is just the calibre. When printing the diameter of the bullet should be **11.95mm** and the height should be **84mm**.
Print with Brim enabled. It shouldn't need any supports. Use whatever infill setting you like (I used 20% but that's probably overkill).
I printed three of these on my Ender 3 v2 neo using Creality brand PLA with the settings mentioned above. They each took 1 hour and 20 minutes.

There are four versions of the bullet:
no hole, no writing (ohne loch - unbeschriftet)
no hole, writing (ohne loch - beschriftet)
hole, no writing (mit loch - unbeschriftet)
hole, writing (mit loch - beschriftet)
The writing just says "7x64" and the hole is for if you want to put it on a keychain or necklace or whatever.

I made this model in Fusion360