Thingiverse
8" Knife Cover
door guitarist809
6
Downloads
5
Likes
0
Makes
Covers an 8" knife. Has slots to allow moisture to dry if not totally dry when putting away.
Use a 0.4mm nozzle. PETG or something other than PLA recommended (since PLA is so brittle). 0.1mm layer height.
No supports needed, print on the thinner edge. I didn't use a brim but it may be necessary if you don't have enough adhesion.
Use a 0.4mm nozzle. PETG or something other than PLA recommended (since PLA is so brittle). 0.1mm layer height.
No supports needed, print on the thinner edge. I didn't use a brim but it may be necessary if you don't have enough adhesion.
guitarist809 publiceert ook op
6 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
