Thingiverse
8" LED Pixel circle
par tygunn
31
Téléchargements
8
Likes
0
Makes
A small 8" LED pixel circle/wreath, fits 69 standard "bullet" pixels.
Push each pixel in with the "tabs" aligned with the four notches around the holes. Push the pixel through and give it a little twist so that the pixel "tabs" secure it in place. See the picture for what this looks like.
Push the pixels in per the standard xLights "circle" wiring diagram; use the attached xLights model for the number of pixels per row and all that. The standard xLights circle model is used with 69 nodes, and the following layer sizes: 1,8,12,24,24.
The circle is shown in the correct mounting orientation in the photo with it having no pixels in it. Yes, the mounting holes aren't horizontal/vertical. :) There are #8 holes on the tabs you can use to mount the prop. I'm going to just use 1/2" conduit clamps to mount the props either horizontally or vertically to 1/2" EMT.
Push each pixel in with the "tabs" aligned with the four notches around the holes. Push the pixel through and give it a little twist so that the pixel "tabs" secure it in place. See the picture for what this looks like.
Push the pixels in per the standard xLights "circle" wiring diagram; use the attached xLights model for the number of pixels per row and all that. The standard xLights circle model is used with 69 nodes, and the following layer sizes: 1,8,12,24,24.
The circle is shown in the correct mounting orientation in the photo with it having no pixels in it. Yes, the mounting holes aren't horizontal/vertical. :) There are #8 holes on the tabs you can use to mount the prop. I'm going to just use 1/2" conduit clamps to mount the props either horizontally or vertically to 1/2" EMT.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
