8 minute Face Shield

Hi, Updated file V33 at bottom of page, New today 7 minute print time, print G code included.

Prints face shield minus the A4 shield plastic,, in my case a clear file cover i found, poked
holes in with solder iron. And some string.


Print complete, cleaned and assembled in 8 minutes. Key is 1mm extruder tip and settings.

Below is old 9 minute visor. v20 file. "go to bottom for new file"
print less than 250mm
by 150mm
by 5mm



print settings. "Done on my makerbot replicator".

1mm extruder tip. "yip i drilled it". ########******************
infill. 0%
layer hight. .6
number of shells 1
feedrate mm/s 50
Travel feedrate 75
print temp 230

HBP 32

PLA

Magnetic flexable build plate, builders tape. sometimes scuff tape a little with sand paper.


This file worked and printed at these settings, better settings of course may be possible t